Skid Steer Cab Heater | Eterra
See more by Eterra Attachments
SURCHARGES:
Over the past several months we have seen a steady increase in pricing from our suppliers due to the current volatile economic landscape. While we have worked hard to absorb as many of these expenses as possible, we have reached a point where we must pass a portion of these increases on to the marketplace. As you will note from our revised pricing, we have done so in the form of a surcharge to reflect in full transparency the impact of these recent increases on our products. We will continue to closely monitor our input costs as well as work with our suppliers to offer the most competitive pricing we can going forward.
Thank you for your understanding and continued support.
SKID STEER SOLUTIONS
- Bulk Pricing:
- Buy in bulk and save
- Buy 10 or above and get 10% off
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
Product overview
Eterra Skid Steer 12 Volt Cab Heater - Fits all models - 12 Volt Only
Description
The Eterra Maradyne Cab Heater uses your existing cooling system to draw heat, and puts out 12,500 BTU. Our price includes the heater and 3 Speed switch kit with minimal wiring. An installation kit is sold separately which includes the hosing required and the common fittings used to install. Please check your block as our kit utilizes SAE threaded fittings, while many blocks use metric threads.
Installation
The installation kit is necessary to install the heater in your machine's cab. Please note that you are responsible for all wiring in your skid steer, this will include a hot/fused lead from your battery to the switch. You are then required to properly ground the base of the heater to insure a complete circuit to the fan motor.
You need to have some mechanical expertise to do this and we want you to understand that this will take you about 5 hours to install. There is no easy way to do this. You will need an open spot on the floor to mount the heater. You will then have to break into the cooling system and run the lines that you will supply to the sides of the heater. You have to allow for the extra length when you lift the cab up. Keep your eye on the prize because once you are done, you will be in a toasty cab as you plow the winter roads!
Looking for an easier (and cheaper) option to stay warm in your cab? Check out this Heated Seat Cover from Skid Steer Basics.
Warranty: The tube and fin water coil have a lifetime mfg. warranty, please see the Skid Steer Solutions warranty page for more about warranties on our products.
Important Notice: This heater is NOT for use on oil cooled units! This item is only designed for water cooled equipment. Please check your cooling system requirements prior to ordering.