Skid Steer Cab Heater | Eterra
See more by Eterra Attachments
A surcharge of $ is included to off-set the rising costs of steel | Learn more
- Bulk Pricing:
- Buy in bulk and save
- Buy 10 or above and get 10% off
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
STEEL PRICES RISE:
The carbon steel market is poised to grow by 699.35 MT during 2020-2024 progressing at a CAGR of almost 8% during the forecast period." (Source: Business Wire)
This is what we are seeing all across the industry; day after day new emails from vendor's telling us that their prices are rising, every order we make for materials needs to be revised because the last price is no longer valid, and for good reason. The cost of steel materials has been steadily increasing throughout 2020, and it unfortunately has not slowed into 2021. The reduced capacities of companies in this industry due to Covid-19 health and safety regulations continues to have an impact. As a result, we are forced to increase our list pricing for 2021 and add a steel surcharge to off-set the rising costs that is projected to continue this year. We apologize for any inconvenience this may have on our close and prospective customers. We we will do what we can to keep our prices low when the opportunities are found, but right now we are left with little options.
Thank you for your understanding and continued support.
JORDEN LEIB, VICE PRESIDENT OF SKID STEER SOLUTIONS
Eterra Skid Steer 12 Volt Cab Heater - Fits all models - 12 Volt Only
The Eterra Maradyne Cab Heater uses your existing cooling system to draw heat, and puts out 12,500 BTU. Our price includes the heater and 3 Speed switch kit with minimal wiring. An installation kit is sold separately which includes the hosing required and the common fittings used to install. Please check your block as our kit utilizes SAE threaded fittings, while many blocks use metric threads.
The installation kit is necessary to install the heater in your machine's cab. Please note that you are responsible for all wiring in your skid steer, this will include a hot/fused lead from your battery to the switch. You are then required to properly ground the base of the heater to insure a complete circuit to the fan motor.
You need to have some mechanical expertise to do this and we want you to understand that this will take you about 5 hours to install. There is no easy way to do this. You will need an open spot on the floor to mount the heater. You will then have to break into the cooling system and run the lines that you will supply to the sides of the heater. You have to allow for the extra length when you lift the cab up. Keep your eye on the prize because once you are done, you will be in a toasty cab as you plow the winter roads!
Looking for an easier (and cheaper) option to stay warm in your cab? Check out this Heated Seat Cover from Skid Steer Basics.
Warranty: The tube and fin water coil have a lifetime mfg. warranty, please see the Skid Steer Solutions warranty page for more about warranties on our products.
Important Notice: This heater is NOT for use on oil cooled units! This item is only designed for water cooled equipment. Please check your cooling system requirements prior to ordering.
JP Excavator Couplers