Skid Steer Tire Studs | Eterra
See more by Eterra Attachments
SURCHARGES:
Over the past several months we have seen a steady increase in pricing from our suppliers due to the current volatile economic landscape. While we have worked hard to absorb as many of these expenses as possible, we have reached a point where we must pass a portion of these increases on to the marketplace. As you will note from our revised pricing, we have done so in the form of a surcharge to reflect in full transparency the impact of these recent increases on our products. We will continue to closely monitor our input costs as well as work with our suppliers to offer the most competitive pricing we can going forward.
Thank you for your understanding and continued support.
SKID STEER SOLUTIONS
Product overview
Eterra Skid Steer Tire Studs for Rubber Tires and Tracks
Description
Eterra Tire Studs are designed specifically for heavy equipment, and are ideal for icy conditions and winter traction.
The aggressive design of these studs has been a monumental success. Being more aggressive is a great thing except when working on roads and driveways that must not be scratched, but if you need something that will keep you safe on the iciest of roadways, Eterra Tire Studs are the studs for you.
Eterra Tire Studs use a screw in design with a hex head and a flat base that holds the large carbide out and able to bite in the toughest conditions. These studs will not tear out of your tire or track. As the carbide wears, you are still left with a head to remove and replace the studs when needed. This will be a very long time just because of the amount of wear that these studs are designed to take. Some Eterra studs have achieved 600 hours and can still be removed and used again. Now that is value!
Insertion is easy using just a powered screw driver and a plain old socket. Removal is just as easy. You will find that you can get more than one season out of these studs as they are completely reusable.
It is the customers responsibility to measure the correct depth or you may damage your tires.
Correct Installation
- Use a low torque driver at fairly slow speed
- Screw the stud in until the washer (underside) makes contact with the rubber visually
- Go no more that 1/2 turn past that point.
- We recommend using 30mm or 1" studs for skid steer or compact loader installations because of the amount of tearing action the machines can produce when turning. It is your responsibility to measure and order the correct length to insure they cannot pull out. It they are too short, they will pull out.
Basic Installation Rules
Never fit a stud that is too long for the tread depth, i.e. an 18 mm stud requires a 17 mm tread depth. 3 mm of the stud should be raised above the tire surface, which gives a margin of 2 mm down to the cord. The thickness of the cord varies between 4 and 20 mm depending on the tire type.
To achieve optimal results, count the number of contact patches on the tire and make a strategy for fitting the studs.
Eterra Tire Studs are easily fitted and dismounted using a simple socket. No special tooling is required.
Disclaimer
Studs are designed to add traction to your tires by adding a solid bite to your tires/tracks. This bite can easily break through snow and ice and scratch the base surface. In the case of a driveway, these scratches will leave marks. Care must be taken not to skid turn on important surfaces where you do not want to leave a mark. This means, if you do not want to scratch your clients driveway, you need to be careful or do not use studs. In most cases these marks are not permanent and will just wash or wear away after a few rain storms. Please note that Skid Steer Solutions or our stud manufacturer do not assume any liability with how you use this product.
