Since their inception 4 years ago, these blades have proven to be winners.  Take a close look at the photos and you will see a resemblance to real bull dozer blades.  This has been modeled because the machines are becoming so large and powerful that you need a real blade to perform real work.  Many of the cheaper blades use a thin mold board with just some angle iron for structural integrity.  This method is insane!  It is a carryover from a snow blade.  Works well in the snow, but it just will not hold up in the dirt.

Our mold boards are heavier and are drilled for a replaceable universal cutting edge.  That is only the start.  We then enclose the back of the blade with a tubular structure to give it structural integrity.  The blade cannot possibly twist when doing heavy work.  On the six way blade, you need to be able to pivot the blade up and down 10 degrees.  Cheaper blades accomplish this with either a pin, bolt or hinge point to pivot around.  We include another tubular structure that follows right out to the end of the blade and slides inside grips just like a real bull dozer.  This method insures that you can work the blade hard and not have it twist.  Yes you can use this blade on an ASV RC100 with 115 HP and the combination will perform just like a small bull dozer.

Specifications:

• Full six-way hydraulic power with 10 degrees tilt both left and right for working both sides and in confined areas.
• Heavy duty rectangular tube frame construction for strength and exceptional durability.
• Replaceable cutting edges are Universal Grader Bits which ensure replacement availability.
• Adjustable skid shoes.
• 3,000 pound (PSI) welded cylinders.
• Multiple sizes available in widths from 6 to 8 feet.
• Mounts close to the loader arms for additional control.
• Extra wide, high abrasion resistant skid shoes.

Kit includes an electric over hydraulic spool valve with the full wiring harness to allow you to wire this unit up to your machine.  Again watch the cheaper blades as often they do not include anything but the hoses and you have to figure it out on your own how to make the controls works.  If you already have switched 12 volt lines like a 14 Pin connector on your boom, we can advise you how to wire this to allow you to run this right off of your stock controls.

Another advantage of buying this product from Skid Steer Solutions, We actually use these products and know how they perform on the different machines.