Break-out Power - 14,500 lbs.
Boom Reach with Bucket Installed - 7' 6"
Weight - 410 lbs. w/o buckets
Mechanical:
Main Tube - 4" Square with 1/4" gussett side plates.
Boss End - 4" Solid 4140 main - machined with press in replaceable bushings
Base plate - Unique dual plate design keeps the plate light and stiff while allowing two pin surfaces for your quick attach to grab. A special angle tube is embedded into this as an additional stiffener.
Mounting slots are set for all universal mounts as well as Case 18 series and Bobcat 400, 500 and 600 machines.
Hydraulics:
Main Bucket Sweep - 3" Bore and 12" Stroke e/w adjustable pressure relief (Protects your boom and pins from damage)
Thumb - 2" Bore x 12" Stroke
Hydraulic Controls:
Single 2 Port in, 4 port out electric over hydraulic industrial fluid control solenoid. Rated to 25 GPM and 4000 PSI
Wiring:
Generic Kit - This kit is supplied if you do not have your own electrical controls on your skid steer. It features a commerical grade switch kit that mounts on your left control stick and back to your battery. There is an extension wire furnished that runs out your boom to where your hydraulic controls connect. When you mount your backhoe, you connect our hoses and the wire end connector and you are ready to go. You would operate your right thumb control on your machine to open and close the bucket. You push the switch in and then operate your right thumb control to open and close the thumb.
14 Pin and 8 Pin Kit - If your machine has an auxilliary wiring kit installed, we can furnish an adaptor plug that will allow you to plug the backhoe right into your factory controls. This makes the function seamless to the operator. You would open and close the bucket with your right thumb control and open and close the thumb with your left thumb control.
Bobcat 7 Pin kits. At this time we are unable to accomodate this control. A 14 pin kit can be added to your existing 7 pin control and would allow our backhoe to function with your Bobcat.
